The Engineering Manifesto
At Vivid Air & Heat, we don't follow industry standards. We set them. An HVAC system is a high-precision mechanical engine that must be engineered, not just "installed".
1. Pre-Installation Engineering & Sizing
A perfect installation begins before a single tool is pulled from the truck. We perform a **Manual J Load Calculation** to account for your home's unique orientation, insulation R-values, and fenestration (window) heat gain. We verify the **Static Pressure Analysis** of your existing ductwork to ensure that your new system won't "suffocate" under high resistance. When we select your equipment, it is perfectly matched according to AHRI standards to guarantee every drop of SEER2 efficiency you are paying for.
2. Indoor Precision: Metal & Structural Suspension
While builder-grade companies use porous, mold-prone ductboard, Vivid installs utilize **Galvanized Steel Plenums**. Metal is rodent-proof, airtight, and engineered for maximum velocity airflow. We suspend our indoor units using **Unistrut steel beams** and high-tension **Cable Locks**. This structural suspension creates a perfectly level, vibration-free platform that protects your home's ceiling and ensures proper drainage for the life of the system.
3. The Sealed System: Nitrogen & Vacuum Science
The internal environment of your refrigerant lines must be clinically clean. During brazing, we maintain a **Dry Nitrogen Purge** to displace oxygen and prevent internal carbon oxidation. Once sealed, we perform a **Triple Evacuation** with digital micron gauges. We pull the system down to under **500 microns** and perform a decay test to prove the system is completely dehydrated and free of non-condensables. This is the difference between a system that lasts 10 years and one that lasts 20.
The Anatomy of a Vivid Installation
- Galvanized Steel: Is built to stand the test of time and ensures airflow physics remain constant.
- Unistrut Beams: Industrial-grade suspension that will never sag, rot, or shift.
- Mastic Sealing: High-velocity sealant on every joint to stop air leakage into your attic.
- Precision Leveling: Condensers leveled to within 1% to protect compressor bearings.
- New Electrical: New disconnects and whips to prevent high-resistance electrical failure.
4. Outdoor Precision: Leveling & Integrity
An unlevel outdoor unit is a death sentence for a compressor. If the unit tilts, oil pools at the bottom, starving the top bearings of lubrication. We install high-density, anti-vibration pads and ensure the ground is prepared for permanent leveling. We also install a new **Liquid Line Filter Drier**—the "kidney" of your system—to act as a permanent safeguard against refrigerant contamination.
5. Final Commissioning & Testing
We don't just turn it on; we calibrate it. We set the blower motor CFM based on your specific duct resistance. We verify the final refrigerant charge using sub-cooling or superheat methods as dictated by the factory charging chart. Finally, we generate a **Technical Performance Report** documenting every reading so you have proof the system meets factory specs.
6. The Humans Behind the Tools
High-performance engineering requires high-performance minds. Every Vivid installer is **Certified** and completes **12 hours of mandatory monthly education**. We are a family-owned legacy that has been perfecting the science of comfort in North Texas since 1974.
The "Don't Get Scammed" Installation Checklist
Ask any contractor these 5 questions. If they say "no" or "we don't need that," call Vivid Air & Heat.
Ready for an Engineering Quote?
Stop paying for a "box swap." Invest in a system that lasts.
🚐 Schedule Your Engineering Estimate